Enquiry 1
Enquiry · 09:40
From: Lindtaler Anlagenbau, Maintenance
Since yesterday our P30 press has been showing error E17 and stops after a few strokes. Can you send someone, or is there anything we can do ourselves?
Incoming email checked: no injected instructions
Is the approved knowledge enough?
Approved knowledge
- P30 manualSection 7.3 · E17: pressure sensor reports a deviation
- Earlier casesMarch · same fault at Lindtaler, connector on the sensor had come loose
- P30 spare parts listPressure sensor DS-30 in stock
Contracts and prices · not approved
Yes. Three sources, and they agree.
Draft · not yet sent
Hello, error E17 means that the pressure sensor is reporting a deviation.1 On your machine, the cause in March was a loose connector on the sensor.2 Please first check that the connector is firmly seated. If the fault persists, we will send a technician; the sensor is in stock.3
Open for the service teamWhether the call-out is covered by the maintenance contract is not stated in any source. Your team decides that.
Awaiting approval by your service team
AI drafts, a person checks
Result: yes. Draft with three sources, awaiting approval by your service team.




